LINEEYE CO., LTD.
Firmware Version History for OP-SB7GX
Version. 2.04 May. 20, 2019
- Corrects the bug in which when used remotely and "AUTO SAVE FILE EXIST" alert is displayed it cannot start measurement because it returns error. (The bug occurs by LE-3500R series only)
- Corrects the bug in which the configuration for IDFILTER of CAN configuration turns to be "OFF" when re-turning on the power although "ON" is set before turning off the power.
- Corrects the bug in which the firmware of Version 2.00 or later cannot be loaded to LE-3500 series causing an error (Invalid Firmware).
Version. 2.03 Nov. 30, 2018
- New function to transmit the measurement log file to a PC via Wi-Fi while measuring
[ detail ]
Version. 2.02 Feb. 26, 2018
- Internal processing has been optimized
Version. 2.01 Oct. 5, 2017
- Integrated the firmwares for LE-2500/LE-3500 and for LE-2500R/LE-3500R.
Note: There is no improvement of function with this version.
Version. 1.03 Jan. 23, 2013
- Add information of analyzer in the measured data.
- Add information of analyzer and date of measuring in front of text conversion data or print-out data.
- Improve access timing to the CF card.
- Add file size of 16M byte in the Auto save function.
- Correct a bug of print-out data and other minor bugs.
Version. 1.02 Apr. 2, 2012
- Support 16G byte CF card updated by LE-3500 version 1.06.
Version. 1.01 Mar 6, 2012
- Support baud rate of LIN up to 26Kbps for a margin test. (Before: 20Kbps)
- Improve the configuration of "FRAME TIME" (frame end time).
- Add outputting wake-up signals supported by LIN Rev2.0 or above.
- Change the display of receiving illegal frames to be same as OP-SB87.
- Change the initial value of INTERVAL (schedule transmission cycle) for LIN simulation to 200ms.
- Correct a minor bug of loading configuration files of OP-SB7FX on a CF card.
- Change the display."DATA ERROR" is displayed when files on an non-supported CF card is loaded.
- Correct the bug that trigger switch, which is a selection of trigger actions, does not be applied.
- Correct the bug of improper position of sweep data after configuration of LIN schedule.
- Correct the bug that inner pull-up resistor is not turned ON/OFF correctly.
- Correct a minor bug of outputting text.
[ detail ]
Version. 1.00 Sep 1, 2009