Please advice me about the control timing of RS-485 driver for rs-485 half-duplex connection when LE-series is in the simulation.
If the version of your analyzer is 1.08 or later, make the driver active just before the data transmission, and make the driver non-active when the time is 3bit of the baud rate after data transmission.
In a former version, make the driver active just before the data transmission, and make the driver non-active when the time is 16bit of the baud rate after the last logic "1" on the RS-485 line is detected.
In a former version, make the driver active just before the data transmission, and make the driver non-active when the time is 16bit of the baud rate after the last logic "1" on the RS-485 line is detected.